SPA-H marking steel for sheet coil and pipe

We have Business Department, Transportation Department, Document Department, Shipping Department, E-C department, Procurement Department, Finance Department, Human Resources Department, Administration Department, Logistics Department, After-sales so on Departments. Each department performs its own duties, unites and cooperates, and contributes its greatest strength to the overall operation of the company. So as to ensure the stable and sustainable development of the company.

SAE4340, same as UNS G43400. Tensile strength σb ≥980(100) Yield strength σs ≥835(85), used to manufacture important parts with high strength and good plasticity. After nitriding treatment, make important parts with special functional requirements, such as shafts, gears, and gears. Firmware etc. Delivery SPA-H marking in heat treatment (normalizing, annealing or high temperature tempering) or without heat treatment.

SPA-H marking, A572 Grade 50 steel with the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the A572 Grade 50 steel coil thickness should not exceed 25 mm. For A572 Grade 50 steel, the C element content is 0.23%, the Si element content is 0.4% max, the Mn element content is 1.35% max, the P element content is 0.004% max, the S element content is 0.05% max, the V element content is 0.06%, the Ni element content is 0.015%, the Co element content is 0.05%.

Preheating cutting: The most effective way to prevent steel plate cutting cracks is to preheat before cutting. Before flame cutting, the steel plate is usually preheated, and the preheating temperature mainly depends on the quality level and thickness of the steel plate. The preheating method can be carried out with flame burner, electronic heating pad, or heating furnace. In order to determine the preheating effect of the steel plate, the required temperature should be tested at the heating point.

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.

The company focuses on quality building, continuously create greatest value for customers, and has achieved good economic and social benefits. With strong financial strength, advanced management experience, perfect sales services, strict quality purchase management system and science overall marketing means. We are willing to go hand in hand with you for common development. To be the best service provider for iron & steel products globally is our goal.