What is meaning of A588 Grade B structural shapes

At the same time of doing well in A588 Grade B structural shapes production and operation, Yunnan company focused on completing the four phases of technical transformation construction projects, realizing industrial upgrading, improving equipment level, and laying a good foundation for the future development of the company. In the A588 Grade B structural shapes technological transformation project, pollution control facilities have been built synchronously, and a large number of comprehensive utilization projects, such as comprehensive sewage treatment and recycling project, blast furnace gas waste heat and residual pressure power generation, have been invested and constructed.

The main steel plates for oil and gas pipelines are X42, X46, X52 (L360), X56 (L390), X60 (L420), X65 (L460), X70, X80. The specification range of steel plate used by the company for oil and gas pipelines: thickness 8mm-60mm. It can produce additional flaw detection requirements and Z15-Z35 tear resistance (thickness direction performance) steel plates A588 Grade B structural shapes, and can also provide Z-direction performance steel plates according to ASTM A770 and other standards.

A588 Grade B structural shapes, 30CrMnSiA steel plate is a kind of low alloy high strength steel with medium carbon, high strength and good weldability. After quenching and tempering, 30CrMnSiA steel has high strength, enough toughness and good hardenability. After quenching and tempering, 30CrMnSiA steel can be used as grinding wheel shaft, gear and sprocket. 30CrMnSiA steel has good processability, small deformation and good fatigue resistance. 30CrMnSiA steel is usually used for shaft, piston parts, etc. It is used for various special wear-resistant parts of automobiles and airplanes.

Rolling steel is the process of pressing to change the shape of the ingot and billet between the rotating rolls. The so-called steel rolling process is a combination of a series of steel rolling processes. The entire rolling production process is always composed of the following A588 Grade B structural shapes basic processes: ① billet preparation:Including the cleaning of surface defects, the removal of surface scale and the pre-heat treatment of billets. ② billet heating ③ steel rolling: it is the core of the entire rolling production process. ④ Finishing.

"SA572 Grade 60 [415] steel chemical composition(%)Carbon max.: 0.26Manganese max.: 1.35Phosphorus Max.: 0.04Sulfur Max.: 0.05Silicon max.: 0.40A588 Grade B structural shapes, SA572 Grade 60 [415] steel mechanical propertiesTensile strength min. MPa: 415Yield strength min. MPa: 520Elongation % min. in 200mm : 16Elongation % min. in 50mm : 18"

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.