Popuar 2mm ASTM A242 CE maximum factory price

Nowadays, transportation is an important factor in economic development. Our company's rapid development is also inseparable from a good geographical location. The company is located in Zhengzhou, an important ASTM A242 CE maximum heavy industry area in Central China. Whether you are in Beijing, Shanghai or Guangzhou, you can visit our company very easily. My factory is nearby, convenient transportation and time saving.

Steel is the main raw material for shipbuilding and marine engineering structure construction, accounting for 20% ~ 30% of the construction cost of hull and marine engineering. The steel ASTM A242 CE maximum products involved mainly include steel plates and section steel (marine bulb flat steel, H-beam, angle steel, etc.), casting and forging steel and supporting welding materials, etc. Among them, the amount of steel consumed for hull construction accounts for about 60% of the total ship mass, and sheet metal accounts for about 88%.

Special boiler steel is derived from carbon structural steel, ASTM A242 CE maximum. The expression of boiler steel grade is similar to that of high-quality carbon structural steel, and the carbon content is usually 0.20%. The chemical composition of boiler steel is basically the same as that of high-quality carbon structural steel of the same brand, but the mechanical properties are strictly required, especially the impact toughness, and the aging sensitivity is required to be small. After deoxidation and removal of non-metallic inclusions, boiler steel has a uniform structure, the grain size is controlled at 3-7 grade, and the defects such as interlayer, shrinkage, porosity and porosity are relatively less.

The wear-resistant plate has the main advantages of high strength and hardness, good toughness, ASTM A242 CE maximum high tensile strength, good material wear-resistance, long service life and low cost. In order to verify the wear-resistant life of the high wear-resistant composite steel plate applied in the field, the comparative industrial test of ASTM A242 CE maximum wear-resistant with the ordinary carbon plate was carried out on the reclaimer of Jigang raw material plant, and the effect is good.

The chemical composition difference between ASTM A242 CE maximum, Q235B and 20# steel is as follows:
The chemical composition of 20# steel: C: 0.17-0.23%, Si: 0.17-0.37%, Mn: 0.35-0.65%, Cr: ≤ 0.25%, Ni: ≤ 0.30%, Cu: ≤ 0.25%. Chemical composition of Q235B steel: C: ≤ 0.20%, Si: ≤ 0.35%, Mn: ≤ 1.40%, P: ≤ 0.045%, S: ≤ 0.045%.
The difference of mechanical properties between ASTM A242 CE maximum, Q235B and 20# steel is as follows:
The mechanical properties of 20# steel: tensile strength 410 MPa; yield strength 245 MPa; elongation after fracture: 25; reduction of area: 55; no impact. Q235B steel mechanical properties: tensile strength 370-500 Mpa; yield strength: ≥ 235 Mpa; elongation after fracture: 25; impact absorption energy: 27J.

The after-sale service of iron and steel products includes after-sale tracking service, technical guidance, transfer of relevant bills, handling of objections and many other contents. The handling of quality objections accounts for a large proportion. When dealing with these problems, we should distinguish the responsibilities, and compensate or return the inconvenience or loss caused to users due to steel.