2mm 4mm 6mm 8mm 10mm thick A588 Gr A plate mill

The company produces export various steel grades of boiler plates: Q345D steel plate, Q345E boiler plate, Q345R boiler plate, Q345R steel plate manufacturers, Q345R boiler plate prices, P355GH boiler plate, 16Mo3 boiler plate, 16MnR boiler plate, 15CrMoR pressure vessel plate, SA516GR60 boiler plate, A588 Gr A plate mill, 20G steel. Boiler plates size range: thickness 8-650mm, width 1500-4020mm. Besides, we also can supply boiler plates various shapes with deep processing service.

The steel such as A588 Gr A plate mill delivered in the hot-rolled state has a certain degree of corrosion resistance due to the high temperature, so it can be stored in the open air. However, this layer of oxide scale also makes the hot-rolled steel surface rough and the size fluctuates greatly. Therefore, the steel with smooth surface, accurate size and good mechanical properties is required to be produced by using hot-rolled semi-finished products or finished products as raw materials and then cold rolling.

Weathering steel generally adopts the process route of fine material into the furnace-smelting (converter, electric furnace-microalloying treatment-argon blowing-LF refining-low superheat continuous casting (feeding rare earth wire)-controlled rolling and cooling. The scrap steel is added into the furnace together with the charge, and smelted according to the conventional process. After the A588 Gr A plate mill steel is tapped, deoxidizers and alloys are added. After the molten steel is treated with argon blowing, the molten steel is cast. By adding rare earth elements to the steel, the A588 Gr A plate mill weathering steel is purified and the content of inclusions is greatly reduced.

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.